IDEC MICROSmart FC6A Series User Manual page 86

2: P S
RODUCT PECIFICATIONS
(1) Battery Holder
This holder is for installing the backup battery.
(2) SD Memory Card Slot
This slot is used to insert the SD memory card.
(3) Power LED [PWR]
This LED turns on when the power is supplied to the CPU module.
(4) Run LED [RUN]
This LED turns on while the CPU module is running the user program.
This LED flashes when using certain functions while the user program is running.
LED
ON
Slow flashing (1 s cycle)
Quick flashing (100 ms cycle)
(5) Error LED [ERR]
This LED turns on when an error occurs in the CPU module.
(6) SD Memory Card Status LED [SD]
This LED turns on or flashes when the SD memory card is being read or written.
LED
OFF
ON
Slow flashing (1 s cycle)
Quick flashing (100 ms cycle)
(7) Battery Status LED [BAT]
This LED turns on or flashes when the backup battery level is low.
LED
OFF
Flashing (1 s cycle)
ON
(8) Status LED [STAT]
This LED can be turned on or off in the user program.
(9) Input LEDs [IN]
These LEDs turn on when the corresponding input is on.
(10) Output LEDs [OUT]
These LEDs turn on when the corresponding output is on.
(11) Expansion Connector
This connector is used to connect an expansion module.
(12) Output Terminals
These terminals connect output devices such as electromagnetic switches and solenoid valves. The CPU module is available
in the relay output type (240V AC: 2 A, 30V DC: 2 A), the transistor sink output type (0.5 A), and the transistor protection
source output type (0.5 A).
2-50
• While the CPU module is running the user program
• When executing the forced I/O function while the user program is running
• While the CPU module is in USB boot
• When executing the forced I/O function while the user program is stopped
• When the SD memory card is not inserted
• When an unsupported or unformatted SD memory card was inserted
• Unmount SD memory card (M8072) is on, so the SD memory card has been unmounted
• When the FC6A Series MICROSmart power is off
• The standby state where the SD memory card can be written or read
• When the FC6A Series MICROSmart is recognizing the SD memory card
• Unmount SD memory card (M8072) is turned on and the FC6A Series MICROSmart is
unmounting the SD memory card
• Reading or writing the SD memory card
Condition
Battery voltage (D8056) > 2,300
2,300 ≥ battery voltage (D8056) > 2,000
2,000 ≥ battery voltage (D8056)
FC6A S MICROS
ERIES
Status
Status
Normal Sufficient battery level.
Warning Low battery level. Replace the battery.
Dead battery The battery is almost dead. Or no battery.
U ' M FC9Y-B1722
MART SER S ANUAL
Battery Status