IDEC MICROSmart FC6A Series User Manual page 152

2: P S
RODUCT PECIFICATIONS
Terminal Arrangement and Wiring Examples

Caution


■ FC6A-J2C1, FC6A-J2C4
Screw fastened type: FC6A-J2C1
Applicable connector: FC6A-PMTB11PN02
ANALOG
PWR
FC6A-J2C1
For wiring precautions, see "Input/Output Wiring" on page 3-18.
: Fuse
- +
Analog Voltage/
current Output Device
- +
2-wire Analog Output Sensor
*1 24V DC for products with a version number lower than V400. For details on the version number of modules, see "Checking the Version Number"
on page 2-1.
2-116
When connecting the terminal, insert an IEC 60127-approved fuse suitable for the applied voltage and current draw at
the position shown in the following diagram.
(Applicable when equipment containing the FC6A Series MICROSmart is destined for Europe)
Do not connect a thermocouple to a part with hazardous voltage (60V DC or peak 42.4V DC or higher part).
Before turning on the power, always check the wiring. If wiring is incorrect, the analog I/O module may be damaged.
Push-in type: FC6A-J2C4
Applicable connector: FC6A-PMSB11PN02
Terminal No. I/O
24V
12/24V
0V
DC *1
FE
NC NC
NC NC
+
I0+
IN0
-
I0-
NC NC
I1+
IN1
I1-
NC NC
FC6A S MICROS
ERIES
ANALOG
PWR
FC6A-J2C4
U ' M FC9Y-B1722
MART SER S ANUAL