IDEC MICROSmart FC6A Series User Manual page 375

Starting and stopping USB boot
Starting USB boot
Connect a USB cable to the USB port of a computer.
1.
When the FC6A Series MICROSmart's power is not supplied, plug the USB cable (5 V) into the USB port of the FC6A Series
2.
MICROSmart.
Computer
To USB Port
When the FC6A Series MICROSmart is started by the USB bus, the power indicator LED [PWR] is off and the operation indicator LED [RUN] is
blinking.
All-in-One CPU module
The operation indicator LED [RUN] blinks at an interval of 100 ms.
Note: The FC6A Series MICROSmart operating status can be checked with the PLC Status dialog box. During USB boot, USB boot is displayed for
Run/Stop Status.
Stopping USB boot
USB boot can be stopped by unplugging the USB cable from the FC6A Series MICROSmart. USB boot also stops when power (24V
DC, 12V DC, 100-240V AC) is supplied during USB boot, and operation switches to that power (24V DC, 12V DC, 100-240V AC).
Restrictions
During USB boot, peripheral functions other than the USB port and SD memory card do not operate.
USB Maintenance Cable
(HG9Z-XCM42)
A Plug
Plus CPU module
PWR
RUN
ERR
SD
BAT
STAT
FC6A S MICROS
ERIES
To USB Port
Mini-B Plug
U ' M FC9Y-B1722
MART SER S ANUAL
5: F S
UNCTIONS AND ETTINGS
FC6A Series MICROSmart
5-69