IDEC MICROSmart FC6A Series User Manual page 573

■ [PROGRAM_UPLOAD] section keys and parameters
Key
Specifies the name of the ZLD file that
dst_file will be uploaded to the SD memory
card.
Specify to dynamically generate the file
filename_option
name.
*1 If the CPU module serial number cannot be correctly read, filename_option operates as if none was specified.
Restrictions
The maximum number of characters per line is 512 single-byte characters including line feed codes. All the text on the line will be ignored if

there are more than 512 single-byte characters on the line.
Each item must be described as a single line. If a line feed occurs before the end of the line, all characters after the line feed are ignored.

Only line feed codes of the format generally supported by Windows (CR+LF) are supported. If any other line feed format is used, the

autoexec.ini file will fail to run properly.
Data from a semicolon (;) to the line feed code is ignored. The space after the semicolon can be freely used for comments. However, if the

autoexec.ini file is opened in WindLDR and then saved again, comments written after the semicolon will be deleted and the file will only
contain standard comments.
Only strings with single-byte characters can be used.

If the same key appears multiple times, only the bottom key is valid.

Description
Specify the name of a ZLD file in the \FCDATA01\PROGRAM\
folder.


However, when downloading the CPU module system
software, output is turned off regardless of this option's
setting.
sn
none
FC6A S MICROS
ERIES MART
Parameter
The file name is enclosed in quotation marks (" ").
The file name is a maximum of 128 characters.
The file will be created using the serial
number of the CPU module instead of the
dst_file file name.
If the serial number is "12A3456",
"12A3456.zld" is created.
Creates the file using the name specified by
dst_file.
U ' M FC9Y-B1722
SER S ANUAL
11: SD M
EMORY
Default Value
"upload.zld"
none
*1
C
ARD
11-37