IDEC MICROSmart FC6A Series User Manual page 3

Caution notices are used where inattention might cause personal injury or damage to equipment.
Caution
The FC6A Series MICROSmart is designed for installation in a cabinet. Do not install the FC6A Series MICROSmart outside a cabinet.

Install the FC6A Series MICROSmart in environments described in the "FC6A Series MICROSmart User's Manual". If the FC6A Series

MICROSmart is used in places where the FC6A Series MICROSmart is subjected to high-temperature, high-humidity, condensation, corrosive
gases, excessive vibrations, or excessive shocks, then electrical shocks, fire hazard, or malfunction will result.
The environment for using the FC6A Series MICROSmart is "Pollution degree 2." Use the FC6A Series MICROSmart in environments of pollution

degree 2 (according to IEC 60664-1).
Prevent the FC6A Series MICROSmart from falling while moving or transporting the FC6A Series MICROSmart, otherwise damage or malfunction

of the FC6A Series MICROSmart will result.
Wiring must use lead sizes that are appropriate for the applied voltage and current. Terminal screws must be tightened with the prescribed

tightening torque.
Prevent metal fragments and pieces of wire from dropping inside the FC6A Series MICROSmart housing. Put a cover on the FC6A Series

MICROSmart modules during installation and wiring. Ingress of such fragments and chips may cause fire hazard, damage, or malfunction.
Use a power supply of the rated value. Use of a wrong power supply may cause fire hazard.

Use an IEC 60127-approved fuse on the power line outside the FC6A Series MICROSmart. This is required when equipment containing the FC6A

Series MICROSmart is destined for Europe.
 Use an IEC 60127-approved fuse on the output circuit. This is required when equipment containing the FC6A Series MICROSmart is destined for
Europe.
 Use an EU-approved circuit breaker. This is required when equipment containing the FC6A Series MICROSmart is destined for Europe.
Make sure of safety before starting and stopping the FC6A Series MICROSmart or when operating the FC6A Series MICROSmart to force outputs

on or off. Incorrect operation of the FC6A Series MICROSmart may cause machine damage or accidents.
Do not connect the ground wire directly to the FC6A Series MICROSmart. Connect a protective ground to the cabinet containing the FC6A Series

MICROSmart using an M4 or larger screw. This is required when equipment containing the FC6A Series MICROSmart is destined for Europe.
 Do not disassemble, repair, or modify the FC6A Series MICROSmart modules.
The FC6A Series MICROSmart contains electronic parts and batteries. When disposing of the FC6A Series

MICROSmart, do so in accordance with national and local regulations.
FC6A S MICROS U
ERIES MART
' M FC9Y-B1722
SER S ANUAL
Preface-2