Checking/Clearing Error Information - IDEC MICROSmart FC6A Series User Manual

7: HMI F
UNCTION

Checking/Clearing Error Information

This section describes how to check error details and how to clear the error when an error occurs while the user program is
running and an error message is displayed on the LCD.
Checking the Error Details and Clearing the Error
When an error occurs, the following message is displayed.
1.
When an error occurs while user program is
running and the user program stops
Error!
PLC is stopped.
Press OK button for
more details.
Press and hold the
2.
General Error
Execution Error 0
Clear Error
Error details can also be checked from Error Status on the system menu.
Select the error type with the
3.
Only errors that have occurred are displayed.
General Error
Power failure
Watchdog Timer
Press the (ESC) button.
4.
Select Clear Error with the
5.
General Error
Execution Error 0
Clear Error
Select Yes with the
6.
Do you want to
clear error code?
No
Yes
General errors and user program execution error are cleared.
Note: For details on error information, see "General Error Codes" on page 13-3.
7-38
When an error occurs while user program is running
and the user program continues running
PLC is running.
Press OK button for
more details.
(OK) button. The error code is displayed.
3
(up) and (down) buttons and press the
3
(down) button and press the
3
(down) button and press the
FC6A S MICROS
ERIES
Error!
(OK) button.
(OK) button.
U ' M FC9Y-B1722
MART SER S ANUAL
(OK) button.