IDEC MICROSmart FC6A Series User Manual page 240

3: I
NSTALLATION AND
Assembling the Cartridge Base Module and a Cartridge
The following procedure describes the assembly of the cartridge base module (cartridge slot 1) and an analog I/O cartridge.
Insert a flathead screwdriver into each of the screwdriver slots (two locations) on the cartridge base module (cartridge slot 1)
1.
and remove the dummy cartridge straight off the cartridge base module by pushing down the dummy cartridge tabs.
Screwdriver Slot
Take care with the vertical orientation of the analog I/O cartridge and firmly push the analog I/O cartridge connector onto
2.
cartridge slot 1 on the cartridge base module.
Do not perform this work when the FC6A Series MICROSmart is powered. Otherwise there is a risk of damage.

Caution
Attach and remove the cartridge straight in relation to the cartridge base module. If you attach or remove the cartridge at

an angle, there is a risk of damage or communication failure.
Note: The cartridge base module cannot be attached to the All-in-One CPU module.
3-8
W
IRING
Dummy Cartridge
Cartridge Slot 1
Analog I/O Cartridge
FC6A S MICROS
ERIES
U ' M FC9Y-B1722
MART SER S ANUAL
Dummy Cartridge