IDEC MICROSmart FC6A Series User Manual page 450

7: HMI F
UNCTION
Note: When the Plus CPU module is used,
Select CPU Network 2 Settings with the
Slave Number
CPU Network Settings
CPU Network 2 Settings
HMI Network Settings
The following operations are the same with CPU Network Settings.
Select Setting with the
6.
CPU Network Settings
Setting: Fixed
IP Address
192.168. 1. 5
With the (up) and
7.
Setting:
Fixed
Data Register:
DHCP
Notes:
If you specify Data Register, the network settings cannot be configured because they are acquired from the data registers.

The current network settings can be checked from the status monitor.

Press the (OK) button to change the CPU module's DHCP setting and to display the CPU Network Settings 1 screen.
8.
CPU Network Settings
Setting: Fixed
IP Address
192.168. 1. 5
Next, to change the IP address, subnet mask, gateway, preferred DNS server, and alternate DNS server, see the following pages.
"Changing the IP address" on page 7-17, from step

"Changing the subnet mask" on page 7-18, from step

"Changing the gateway" on page 7-25, from step

 "Changing the preferred DNS server" on page 7-20, from step
"Changing the alternate DNS server" on page 7-21, from step

Press the (ESC) button to display the screen in the following diagram. Select Yes with the
9.
(OK) button.
Do you want to
configure network?
No
Yes
7-16
CPU
Network 2 Settings is displayed.
(up) and (down) buttons and press the
(up) and (down) buttons and press the
(down) buttons, select ON or OFF.
2
2
2
FC6A S MICROS
ERIES
(OK) button.
(OK) button.
2
2
U ' M FC9Y-B1722
MART SER S ANUAL
(down) button and press the