Mounting On Din Rail - IDEC MICROSmart FC6A Series User Manual

3: I
NSTALLATION AND

Mounting on DIN Rail

Install the FC6A Series MICROSmart modules according to instructions described in this manual. Improper installation will

Caution
result in falling, failure, or malfunction of the FC6A Series MICROSmart.
Do not install the FC6A Series MICROSmart when it is powered up. Doing so may result in electric shock and may damage

the product.
This section describes how to mount the FC6A Series MICROSmart.
The FC6A Series MICROSmart can be mounted on a DIN rail or directly to a panel inside a cabinet.
DIN Rail Mounting and Removal
The following procedure describes how to mount and remove the FC6A Series MICROSmart to and from a DIN rail.
Firmly fasten the DIN rail to a panel using screws.
1.
Using a flat head screwdriver, lower the DIN rail hook (1) and hang the FC6A Series MICROSmart on the DIN rail (2).
2.
Align the FC6A Series MICROSmart with the DIN rail (1) and raise the DIN rail hook (2).
3.
Secure both ends of the FC6A Series MICROSmart using the DIN rail brackets.
4.
Notes:
The FC6A Series MICROSmart supports 35 mm wide DIN rails.

Supported rails: IDEC BAA1000 (Length: 1,000 mm)
Rail bracket: BNL6PN10
The FC6A Series MICROSmart can also be mounted by hooking it onto the DIN rail when the DIN rail hook is raised and pushing it on until it

clicks.
3-10
W
IRING
(1) Align with DIN Rail.
FC6A S MICROS
ERIES
(2) Hook FC6A Series MICROSmart over DIN Rail.
DIN Rail
(1) Lower DIN Rail Hook.
DIN Rail
(2) Raise DIN Rail Hook.
DIN Rail Bracket (BNL6)
U ' M FC9Y-B1722
MART SER S ANUAL
DIN Rail