IDEC MICROSmart FC6A Series User Manual page 238

3: I
NSTALLATION AND
Assembling the CPU Module and a Cartridge
The following procedure describes the assembly of the CPU module (cartridge slot 1) and an analog I/O cartridge.
Insert a flathead screwdriver into each of the screwdriver slots (two locations) on the CPU module (cartridge slot 1) and
1.
remove the dummy cartridge straight off the CPU module by pushing down the dummy cartridge tabs.
Screwdriver Slot
Take care with the vertical orientation of the analog I/O cartridge and firmly push the analog I/O cartridge connector onto
2.
cartridge slot 1 on the CPU module.
Cartridge Slot 1
Do not perform this work when the FC6A Series MICROSmart is powered. Otherwise there is a risk of damage.

Caution
Attach and remove the cartridge straight in relation to the CPU module. If you attach or remove the cartridge at an angle,

there is a risk of damage or communication failure.
Note: Cartridges cannot be attached to the Plus CPU module.
3-6
W
IRING
Analog I/O Cartridge
FC6A S MICROS
ERIES
Dummy Cartridge
U ' M FC9Y-B1722
MART SER S ANUAL