Shift Cable - Tracker Off-Road 500S Service Manual

PK064A
4. Remove the taillight/brake light socket by rotating
the socket counterclockwise. Rotate the bulb coun-
terclockwise to remove from socket.
PK328
5. To install the taillight/brake light, insert the bulb into
the socket and turn clockwise. Insert the socket into
the taillight assembly and turn clockwise.
6. Place the rear fender onto the cargo box and secure
with the six plastic screws. Secure the tie-down with
the two nuts and cap screws.
7. Connect the taillight/brake light connector.
CHECKING/ADJUSTING HEADLIGHT
AIM
The headlights can be adjusted vertically. The geometric
center of the HIGH beam light zone is to be used for aim-
ing.
1. Position the vehicle on a level floor so the headlights
are approximately 6.1 m (20 ft) from an aiming sur-
face (wall or similar aiming surface).
0748-733
NOTE: There should be an average operating load

on the vehicle when adjusting the headlight aim.
2. Measure the distance from the floor to the midpoint
of each headlight.
3. Using the measurements obtained in step 2, make
horizontal marks on the aiming surface.
4. Make vertical marks which intersect the horizontal
marks on the aiming surface directly in front of the
headlights.
5. Switch on the lights. Make sure the HIGH beam is
on. DO NOT USE LOW BEAM.
6. Observe each headlight beam aim. Proper aim is
when the most intense beam is centered on the verti-
cal mark 5 cm (2 in.) below the horizontal mark on
the aiming surface.
7. Loosen the headlight adjustment screw; then adjust
the headlight up or down as required. Tighten the
headlight adjustment screw.
PK081A

Shift Cable

CHECKING SHIFT CABLE
Turn the ignition switch on; then shift the transmission
into park. The letter P should illuminate on the LCD
gauge and the park icon (P) should illuminate. The vehi-
cle should not be able to move.
PR098
Move the shift lever all the way forward. The letter L
should illuminate on the LCD gauge.
13