Installing The Bumper Feet; Figure 17: Parts Of The Bumper Feet; Figure 18: Holes For Bumper Feet - Allied Telesis x530L Series Installation Manual

Chapter 3: Installing the Switch on a Table

Installing the Bumper Feet

56
The switch comes with four bumper feet in the accessory kit. The feet,
which are reusable, are used when installing the switch on a table. If they
are already assembled, disassemble them by removing the rivets and rivet
housings from the bumper feet. Refer to Figure 17.
Figure 17. Parts of the Bumper Feet
The holes in the base of the switch for the bumper feet are shown in
Figure 18 on page 56.
Note
Although you cannot stack the switches on top of each other, they
can be placed next to each other.
Figure 18. Holes for Bumper Feet
Rivet
Rivet Housing
Bumper Foot
Rear of Chassis
Front of Chassis