Figure 40: Holes For Bumper Feet; Figure 41: Inserting The Rivet Housing Into The Bumper Foot - Allied Telesis 950 Series Installation Manual

Advanced layer 3+ stand-alone switches
Table of Contents

Advertisement

Chapter 4: Installing the Switch on a Table
82
Figure 40. Holes for Bumper Feet
Note
The following procedure assumes that you have already reviewed
the information and performed the procedures in Chapter 2,
"Beginning the Installation" on page 53.
To install the switch on a table, perform the following procedure:
1. Place the switch upside down on a table.
2. Inset a rivet housing into a bumper foot. Refer to Figure 41.
Figure 41. Inserting the Rivet Housing into the Bumper Foot
Rear of Chassis
Front of Chassis

Advertisement

Table of Contents
loading

This manual is also suitable for:

At-x950-28xsqAt-x950-28xtqm

Table of Contents