Table of Contents
Advertisement
Chapter 3: Installing Power Supplies and Optional XEM2 Line Card
Installing an Optional XEM2 Ethernet Line Card
76
This section contains the procedure for installing an optional XEM2
Ethernet line card in the expansion slot in the front panel of the switch. For
background information, refer to "XEM2 Ethernet Line Cards" on page 28.
The illustrations show the AT-XEM2-12XT Line Card. The procedure is the
same for all line cards.
Caution
The device can be damaged by static electricity. Be sure to follow
proper anti-static precautions when installing the device. Allied
Telesis recommends using a properly grounded wrist strap or other
personal anti-static device and an anti-static mat.
To install an XEM2 Ethernet line card, perform the following procedure:
1. Using a #2 Phillips-head screwdriver, loosen the two captive screws
on the blank expansion slot panel and remove it from the switch. Refer
to Figure 34.
Figure 34. Removing the Blank Line Card Cover
2. Carefully remove the new Ethernet line card from its shipping
container and anti-static bag. Refer to Figure 35 on page 77.
Advertisement
Table of Contents
