Self Test Phase : Fail - Siare Morpheus ND User Manual

4.8.1 Self Test phase : Fail

The Self Test phase did not complete successfully
During the Self Test phase, the software carries out self-diagnostic tests: during this
phase one or more devices essential for safe and correct operation of the anesthesia
unit / patient does not exceed the test (see image: Fail).
WARNING !! Risk for Patient / user injury
•
•
•
•
For further information on ventilation module, and in particular on how to set the
language used on graphic interface (see chapter 4.7.2).
4-26
Individuate the typology of problem detected during the Self Test (see on next
chapter).
Please see on chapter 6: Alarms and Troubleshooting.
Turn OFF the Anasthesia Unit and repeat the Self Test.
If the problem persists, contact the nearest Siare Technical Centre or any other
Technical Centre authorised by Siare.
The Self Test phase was not
completed successfully.
Despite this phase of Self Test has not
been overcome, the system allows to
proceed.
" Press Ok to begin anyway "
User manual, DU33ND101