Ventilator Switch On / Self Test Phase - Siare Falco 202 Evo User Manual

3.3.2 Ventilator switch ON / Self Test phase


Set the main switch (placed on the back of the ventilator) to "I".

Make sure that on the lung ventilator keyboard
(commands area) the green led (that indicates the
presence of mains power supply) is on.

Hold the ON-OFF key for few seconds; the lung ventilator switches ON and the
automatic Self Test phase starts.
During Self Test phase, the lung ventilator software carries out the self-
diagnostic tests and checks a series of devices necessary for safe operation
of the lung ventilator /patient.
3-16
Self Test phase. Please close the
patient circuit.

Turbine: turbine functioning
check and status.

Oxygen emptying: during this
test the system provide to 21%
calibration of the oxygen
sensor.

Insp. Flow Sensor: check the
operation of the Inspiratory
Flow sensor.

Exp. Flow Sensor: check the
operation of the Expiratory
Flow sensor.

Pressure Sensor: check the
operation of the Pressure
sensor.

Electrovalve: check the
operation of the EV1/EV2
electrovalves.
User manual, DU3104101