Removal; Installation - Abbott VP 2000 Service Manual

Repair, Replacement of Spare Parts

Removal

Installation

7-74
1. Remove the Hoods by gently squeezing inward on the two
(2) metal arms that connect the Hoods to the unit.
2. Remove the Top cover by unscrewing six (6) 6-32 x 1/4
Phillips-Head screws, three (3) on each side of the unit.
3. Remove the right-hand side panel by first removing the
four (4) 6-32 x 1/4 Phillips-Head screws holding the panel
in place. Grasp the top of the side panel and pull it away
from the unit.
CAUTION: Depress the plunger on the Interlock
Switches to permit the side panel to move past the
switch as it is pulled forward.
4. Disconnect the Fan Plug at the Fan.
5. Remove the four (4) 6-32 x 3/8 Phillips-Head screws and
the four (4) 6-32 hex nuts fastening the finger guard and
fan to the inner support. Remove the Fan.
Reassemble by following the removal procedure in reverse.
CAUTION: Depress the plunger on the Interlock
Switches as the outer side panel is installed.
CAUTION: Before sliding the Top Cover back into
position, make sure all wiring, cables and connectors
are replaced snugly, within the unit and not hanging
out where they might be sheared off when replacing
the cover.
NOTE: Make sure the fan is oriented with the
connector in the correct position and with the Air Flow
Direction Arrows as shown in Figure 9.25.
NOTE: When replacing the side panel, make sure all
wires and cables are within the unit and out of the way
when the panel is slid into position.
Section 7
Abbott VP 2000™ Processor Service Manual
30-608308/R1—September 2008