Removal; Installation - Abbott VP 2000 Service Manual

Repair, Replacement of Spare Parts

Removal

Installation

7-68
1. Use a thin blade screwdriver to gently pry the switch
housing flange away from the vertical side panel.
2. As the switch is pried sufficiently away from the side
panel, use a screwdriver or other tool to depress the
switch-lock tangs (four (4) places, top, bottom, right and
left) and work the switch away from the side panel.
3. When the switch is away from the side panel, apply
sufficient pressure to the two (2) right or left tangs for final
removal.
4. Disconnect the four (4) insulated spade connectors from
the back of the switch.
1. Install four (4) insulated spade connectors on the switch
lugs following the wiring shown in Figure 7.36. Align the
switch with the cutout in the vertical support and press it
into place.
Section 7
Abbott VP 2000™ Processor Service Manual
30-608308/R1—September 2008