Removal - Abbott VP 2000 Service Manual

Section 7

Removal

Abbott VP 2000™ Processor Service Manual
30-608308/R1—September 2008
Table 7.2:
Heated Basins
o
Basin 1 (80 C)
o
Basin 2 (80 C)
o
Basin 3 (40 C)
Figure 7.31: Heater Basin Insulation
1. Remove the Heater Module Assembly as outlined in the
Heater Module Assembly Removal instructions.
2. Remove the 11 6-32 x 3/16 Phillips-Head screws used to
fasten the Cover Assembly and skirt to the base. Unplug
connector from the sensor bar and lift the cover/skirt away
from the base.
3. Disconnect the green Heater Box ground wires by
removing the 6-32 hex nut securing the wires to the base.
Heater Box Assembly
7-57