Heater Box Assembly - Abbott VP 2000 Service Manual

Repair, Replacement of Spare Parts

Heater Box Assembly

7-56
Prior to disassembly, move the Robotic Arm so that it is over
the Drying Station and leave it in the up position.
WARNING: Always disconnect the system power at the
plug to the wall socket before beginning disassembly of
the unit.
NOTE: When replacing the Heater Basin in the Heater
Module, there may be a white cotton-like pad on the
Heater Module base or in the package with the new
Basin. This material must remain with the Basin as
shown in Figure 7.31. This should have been glued by
the manufacturer to the Basin's bottom area.
Figure 7.30: Heater Box Assembly
Section 7
Abbott VP 2000™ Processor Service Manual
30-608308/R1—September 2008