Purpose Of This Section; Significance Of These Safety Instructions; Introduction - Abbott VP 2000 Service Manual

Safety

Purpose of This Section

Significance of These Safety Instructions

Introduction

2-4
This section contains specific guidelines for operation and
warnings for hazards with regard to installation, setup,
troubleshooting, maintenance, and repair of the Abbott VP
2000 Processor.
Safety of users and personnel can only be ensured if these
safety instructions and safety-related warnings in the other
sections are strictly observed and followed.
Therefore, the Abbott VP 2000 Processor Service Manual
must always be available to all persons performing the tasks
described herein.
In addition to the safety instructions in this Service Manual,
safety instructions in the Abbott VP 2000 User Guide also
apply.
This section summarizes the safety instructions applicable to
the Abbott VP 2000 Processor, and those to be observed when
installing, servicing, or upgrading an instrument. Operation,
maintenance, and servicing of the Abbott VP 2000 Processor
could expose individuals to potential safety and health
hazards. All service must be performed in accordance with
procedures described herein. This section describes the types
and locations of potential hazards that could cause physical
harm to an operator or service personnel. Warnings and
cautions are provided to alert operators and service personnel
of potential hazards. Standard warning conventions, including
hazard signal words or symbols are described in subsequent
sections.
Section 2
Abbott VP 2000™ Processor Service Manual
30-608308/R1—September 2008