Removal; Installation - Abbott VP 2000 Service Manual

Repair, Replacement of Spare Parts

Removal

Installation

7-16
1. Remove the Hoods by gently squeezing inward on the two
(2) metal arms that connect the hoods to the unit.
2. Remove the Top Cover by unscrewing Six (6) 6-32 x 1/4
Phillips-Head screws, three (3) on each side of the unit.
3. Push the Tension Arm toward the X-Motor to relax the
belt tension; remove the drive belt from the motor pulley.
4. Remove the motor pulley by loosening the 6-32 x 3/8
socket cap screw that attaches it to the motor shaft.
5. Unplug the motor cable from the 6-pin harness connector.
6. Remove the motor, by unscrewing the four (4) 8-32 x 3/8
Phillips-Head screws that attach it to the Drive Plate
(accessed from the back of the unit).
Reassembly by following the removal procedure in reverse.
CAUTION: When installing the drive belt on the motor
and idler pulleys, make sure the drive belt is not
twisted.
CAUTION: Before sliding the Top Cover back into
position, make sure all wiring, cables and connectors
are replaced snugly within the unit and not hanging
out where they might be sheared off when replacing
the cover.
Section 7
Abbott VP 2000™ Processor Service Manual
30-608308/R1—September 2008