Introduction - Abbott VP 2000 Service Manual

Section 7

Introduction

Abbott VP 2000™ Processor Service Manual
30-608308/R1—September 2008
This section describes how to remove and install each of the
Field Serviceable Modules in the Abbott VP 2000 Processor.
Observe the following safety notices.
WARNING: Always disconnect the system power at the
plug to the wall socket before beginning disassembly of
the unit.
NOTE: In some procedures it is necessary to move the
Robotic Arm to a specific position before beginning
disassembly. Move the arm first, then disconnect the
power.
WARNING: Potential Biohazard. Indicates an area
where the FSE or operator could be exposed to
potentially infectious human-sourced material.
Contamination hazards exist if parts of the instrument
are not completely decontaminated. Wear appropriate
personal protective equipment such as gloves, lab coat,
and protective eyewear.
CAUTION: Chemical Hazard. The FSE or operator
could be exposed to hazardous chemicals when
handling Abbott Molecular sample preparation
reagents. Exposure to hazardous chemicals is
minimized by observing instructions provided in
product-specific labels and product-specific Material
Safety Data Sheets (MSDS). Wear appropriate personal
protective equipment, such as gloves, lab coat, and
protective eyewear.
WARNING: Electrical Shock Hazard. Possible danger
from electrical shock. Switch off the main power and
disconnect the main power connection of the
instrument before replacing fuses, printed circuit
boards, major sub-assemblies, etc. Replace only fuses
that are externally accessible and labeled. Only use
replacement fuses of the specified type and electrical
rating.
Introduction
7-5