Replacing The Dmd, Dmd Board, And Optical Engine Board - Christie GS Series Service Manual

Replacing the DMD, DMD board, and optical
engine board
Replacing the DMD module must be done in a clean room.
i
To remove the DMD and DMD board, complete the following steps.
1. Remove the light engine, and combiner.
See Replacing the light engine, and combiner
2. Remove the TEC module.
See Replacing the TEC module
3. To separate the DMD board from the DMD module, remove the six M3 screws.
4. Remove the DMD module.
5. Remove the four screws with a Phillips Jewelers screwdriver securing the heatsink.
GS Series 700-850 Service Manual
020-001054-02 Rev. 1 (04-2017)
on page 73.
on page 74.
Optics
75