Replacing The Dmd - Christie DHD410S Service Manual

4. To release the combiner module, remove the six M3 screws with a Phillips #1 screwdriver.
5. Flip and lift the combiner module.
6. Replace the combiner module.
7. To re-install, follow these steps in reverse order.

Replacing the DMD

To remove the DMD board, complete the following steps.
1. Remove the top cover.
See Removing the top cover
2. Remove the main board.
See Replacing the main board
3. Remove the combiner module.
See Replacing the combiner module
4. Remove the light engine.
See Replacing the light engine
5. Remove the four M3 screws with a Phillips #1 screwdriver.
DHD410S Service Manual
020-001481-01 Rev. 1 (10-2018)
on page 46.
on page 77.
on page 73.
on page 71.
Optics
65