Calling Another Unit - Panasonic Windea VGDT18143W Simple Manual

For Base Unit/Call Sub-base Unit with Monitor
1
Call tone "beep" sounds
●
After calling, you will be able to talk for
approximately 10 seconds even without
pressing the TALK button. (The TALK button
lights up in red.)
● After about 10 seconds, the status changes to
the waiting state of answering (the call is ended
once) and the TALK button flashes in red.
● If approximately 30 seconds pass without
any answer after the call tone sounds, the
TALK button will turn off automatically.
2
Press the TALK button to talk
● The conversation will end automatically in
approximately 1 minute from the start of the call.
Note
The conversation time cannot be extended.
3
Press the TALK button to end
● The extension call ends.
For Call Sub-base Unit
1
Call tone "beep" sounds
● After calling, you will be able to talk for
approximately 10 seconds even without
pressing the TALK button. (The TALK button
lights up in green.)
● After approximately 10 seconds, the status
changes to the waiting state of answering
(the call is ended once) and the TALK
button flashes in green.
●
If approximately 30 seconds pass without
any answer after the call tone sounds, the
TALK button will turn off automatically.
2
Press the TALK button to talk
●
The conversation will end automatically in
approximately 1 minute from the start of the call.
Note
The conversation time cannot be extended.
3
Press the TALK button to end
●
The extension callends.
46
Extension Call
(Call with base unit/ sub-base unit)
Receiving a Call
● In the case of a base unit called by
sub-base unit (Room 1) calling all units.
復旧/警報音停止
RESET/ STOP ALARM
電源
火災 FIR E ガス GAS 留守 NOTHOME 警戒 S ET 戸締り OPEN
POWER
●For base unit
VGD13113W VGD13113W
非常
EMERG.
警報 警報 管理 管理 ロビー ロビー
ALARM ALARM MANAGER MANAGER LOBBY LOBBY
解錠
室内呼
UNLOCK
EXTENSION
呼出音量
VOLUME
通話
TALK

Calling another Unit

(For base unit)
For a condominium that supports the unit call function (calling another unit from a unit), it is
enabled to call another unit.
●
Note
●
1
Open the Calling screen
(
2
Touch
●
Depending on the equipment and operating
Note
configuration of the condominium you are
living in, the call destination description differs.
3
Enter the room number of the unit
TALK button
you want to call and touch
●
If you enter the wrong room number, touch
Note
Press
4
Talk once the called unit answers
●
●
5
Press the TALK button to end
●
When Calling a Unit of Another Block
● After Step
Touch the block you want to call first before
proceeding to the operation in Step
TALK button
The display details of the block number vary depending
Note
on the operating configuration of the condominium
HA system.
Press
Other units cannot be called when "Reject Calls" is set for other unit setting in the user
setting in "Ringtones" under "Sound Setting". ( Page 100)
The call sub-base unit is not compatible with calling another unit.
Page 41)
The Number Of The Unit screen
appears.
Touch
The maximum digit to enter for the room
number is up to 4.
Touch
the numeric
first before entering the number again.
buttons
The conversation will end automatically in
approximately 1 minute from the start of the call.
The conversation time can be extended.
( Page 33)
The conversation with other unit ends.
2
, the Other Unit screen will appear.
3
.
1
2
Touch
通話
TALK
Press
Touch
any one
47