Table of Contents
Advertisement
Shortening the Security System
Delay Time from the Door Phone
Performing the following operations from the door phone enables you to immediately arm the security
system for the windows and front entrance door even during the security system delay time.
1
Arm the security system from
the base unit and exit from
the condominium unit entrance
●
Exit from the condominium unit entrance
within the security system delay time
(
page 197).
Make sure to arm the security system from
Note
the base unit before performing these operations.
2
Press and hold the Call button
on the door phone for more than
2 seconds
●
The alarm display indicator on the door
phone appears in red for approximately
10 seconds, the audible message is
triggered, and the security system is
armed immediately.
●
The system can be configured not to
play the message from the door phone
when the security system is armed.
A confirmation sound "beep" can also
be enabled.
(
See page 109 for information on the
External Security Door Phone Sound).
(The sound used when disarming the
security system is also changed.)
194
Alarm display indicator
appears in red for
approx. 10 seconds
Press and hold for
at least 2 seconds
● Door phone with camera
Disarming the Security System While the Preliminary Alarm is Active
(For base unit)
The security system can be disarmed for both the front entrance door and windows during
the preliminary alarm time when returning home.
●
If the front entrance door is opened while the security alarm is active, the magnet switch activates,
and the system triggers the "(Beep) Security is operating." preliminary alarm. Perform the following
operations within the preliminary alarm time (60 seconds).
1
Touch
during the audible preliminary alarm
●
The "Enter the security number." screen appears.
●
The security system stops functioning if no
security number has been configured.
Operations from Step
2
are unnecessary.
Perform the operations within 60 seconds after opening
Note
the front entrance door.
The security alarm will trigger if the preliminary alarm
time elapses.
2
Enter the security number
●
The entered security number appears.
Note
Touch
if in the security number is entered
incorrectly. All numbers will be cleared.
Security
SET indicator
flashes in green
3
Touch
●
If the entered security number is
correct, the Security SET indicator turns
off, and the security alarm is disarmed.
After the security disarmed message is
triggered, and the "Security has been
turned off." message appears on the
screen, the Top Menu screen appears.
●
If the entered security number is incorrect,
the system returns to the "Enter the
security number." screen. If this happens,
2
repeat the procedure from Step
.
●
Note
All security system alarms are disarmed when
disarming procedure is performed. (This is also
applicable to the "Individual Security System" setting.)
●
The same message that plays from the base unit
also plays from the sub-base unit and extension
speakers if connected.
●
The system can be configured not to play the
message when the security system is disarmed. A
disarming sound (short beeps) can also be enabled.
(
See page 108 for information on the Security
Off Sound).
(The sound used when arming the security
system is also changed.)
4
Select the Living mode for which
the security system is set to "Off"
when using Living mode
Security icon
flashes in
yellow
Security
SET
indicator
電源
警戒
flashes
SET
POWER
in green
Touch the
numeric
buttons.
電源
警戒
SET
POWER
Touch
● T he figure illustrates an example
of entering "1234".
<When using Living mode>
Touch
any one
Using default
settings
Security setting
195
Advertisement
Table of Contents
