Connected System Components In Apartment Units (Example) - Panasonic Windea VGDT18143W Simple Manual

Connected System Components in Apartment Units (Example)

The following equipment is typically installed in the condominiums.
If an alarm is set off by a fire or other monitored conditions, the system will trigger alarm sounds and alarm lights.
The installed equipment and functions vary depending on the condominium. To use the system correctly, confirm the
Note
available functions in your system and the actual installed equipment. Contact the management company or building
manager room if you cannot determine the installed equipment or available functions in your system.
EMERGENCY
button
復旧/警報音停止
RESET/ STOP ALARM STOP ALARM
button
FIRE
CONFIRM
button
電源
POWER
Base unit (VGDT model is illustrated)
Water leak sensor
Extension speaker
(*2)
Magnet switch
Security 1 (windows, etc.)
154
EMERGENCY
button
警報音停止
STOP
STOP ALARM
ALARM
button
Call button
電源
POWER
Call sub-base unit with monitor (*1)
Detector
Gas/CO alarm
*1: The extension adapter used for units (sold separately) must be installed to the base unit to use
these devices.
*2: An extension speaker cannot be connected if two call sub-base units are connected.
Alarm display indicator
Location display indicator
Door phone extension
The following devices sound when
or
with alarm display
alarms are triggered.
Alarm display indicator
●
●
Location display indicator
●
●
Door phone with camera
●
External security set switch
Note
(non-voltage a contact)
Magnet switch
Security 2
(entrance, etc.)
EMERGENCY
非常
EMERG. button To clear the screen display before it clears
解錠
室内呼
UNLOCK
EXTENSION
呼出音量
VOLUME
通話
automatically after a predetermined amount of
TALK
Call sub-base unit (*1)
time, press the STOP ALARM button to turn off
the audible alarms and calls and then press the
Residence distribution
OFF button . (The fire confirmation alarm and
board with over-
gas leak alarm sounds can only be turned off
currency alarm
from the base unit.) The area around the MENU
(Data output type)
button will flash in red when the display turns off.
Emergency button
Operation indicators (1 through 4)
Contact output 1
Contact output 2
Contact output 3
Contact output 4
Screen display
Wireless contact
Battery replacement
indicator
output receiver
Devices which sound when
alarms are triggered
Base unit
Call sub-base unit with monitor (*1)
Call sub-base unit (*1)
Extension speaker
Door phone extension with alarm display
or door phone with camera
●
Door phones may not sound depending
on the type of alarm.
●
Call sub-base units and extension speakers
trigger the same sound as the base unit.
Screen display on base unit and
call sub-base unit with monitor
can be turned off.
Press the MENU button to turn on
the display again.
電源
POWER
OFF button MENU button
●
The VGDT model base unit is illustrated.
155