Replacing Pendulum Shaft Bushings; Replacing Bearings In Articulation Unit Belt Pulleys - Husqvarna Rider 100 series Workshop Manual

Replacing the pendulum shaft bushings
Once the swing axle has been remove, the
bushings in the rear frame must be changed.
5
3
6
Remove the cover (1) on the right hand side.
Loosen the spring (2) with a spring hook. Loosen
the screw (3) and the cotter pin (4), then remove
the belt tensioner (5). Remove the bushings (6),
one from each direction.
535 41 32-02
The bushings must be initially lubricated with a
lithium-based grease. New bushings are fitted with
the mandrel, refer to "Special tools".
It is important that the outer bushing's outer edge
is on the same level as the beveled edge of the
hole. When the bushings are positioned, the belt
tensioner is fitted with the spring again.
6
2
1
4
Replacing the bearings in the
articulation unit belt pulleys
1 Remove the articulated shaft with belt pulleys,
refer to "Replacing the Articulated Steering
Bearings", step 1 to 14.
2 Remove the lock rings (3) holding the belt
pulleys (2) and the plastic cover (4) in the upper
and lower sections.
3 Press the shaft (1) out from the belt pulleys (2).
4 Tap out the bearings (5) in the upper and lower
sections.
5 Press new bearings in using a bearing assembly
kit. Assemble in the reverse order.
Repair instructions
3
5
2
5
4
3
1
English – 37