Replacing The Pendulum Shaft Bushings; Replacing The Bearings In The Middle Deck Belt Pulleys - Husqvarna Rider 111 B Workshop Manual

Reparation instructions

Replacing the pendulum shaft bushings

Once the swing axle has been removed the
bushings fi tted to the rear frame must be replaced.
5
3
6
Remove the cover (1) on the right hand side. Loosen
the spring (2) with a spring hook. Loosen the screw
(3) and the cotter pin (4), then remove the belt
tensioner (5). Remove the bushings (6), one from
each direction.
535 41 32-02
The bushings should fi rst be lubricated with a
lithium-based lubricant. New bushings are fi tted
with the mandrel, refer to "Special tools".
It is important that the outer bushing's outer edge
is on the same level as the bevelled edge of the
hole. When the bushings are positioned, the belt
tensioner is fi tted with the spring again.
30
– English
6
2
1
4
Replacing the bearings in the middle
deck belt pulleys
1 Remove the articulated shaft with belt pulleys,
refer to "Replacing the Articulated Steering
Bearings", step 1 to 14.
2 Remove the lock rings (3) holding the belt pulleys
(2) and the plastic cover (4) in the upper and
lower sections.
3 Press the shaft (1) out from the belt pulleys (2).
4 Tap out the bearings (5) in the upper and lower
sections.
5 Press new bearings in using a bearing assembly
kit. Assemble in the reverse order.
3
5
2
5
4
3
1