Error Message Display And Remedies - MUTOH ValueJet VJ-426UF Operation Manual

Display
Ink Refill **%
Discharging
Empty WasteInk ->E
Cover Open
PG Handle Cover Open

Error message display and remedies

This section describes error messages and remedies.
Error messages are displayed when certain failures occur during printer operation.
If an error that can be displayed occurs, the printer may display the following error messages on the operation panel
and stop operation.
Display
[******] Ink End
[******] NoCartridge
[*******] Discharged
Full WasteInkTank
NearFullWasteInkTank
[*] Ink Low
[******] S/C ReadErr
[******] S/C Col.Err
[*] S/C Ink Err
Charging the ink.
Please wait a while.
Discharging the Ink.
Please wait a while.
Transfer the waste ink from the waste ink tank into a container, and press the
[Enter] key.
"Emptying waste ink tank" on page 86
The front cover is open.
The PG handwheel cover is open.
Ink has run out. (Stops operation)
Replace with a new ink cartridge.
"Replacing ink cartridge" on page 85
Ink cartridge is not inserted. (Stops operation)
Insert Ink cartridge.
Ink is not filled.
Perform initial ink charging.
"How to carry out initial ink charging after ink discharge" on page
108
The waste ink tank has become full.
(Operation will stop when this happens.)
Immediately transfer the waste ink into a container.
"Emptying waste ink tank" on page 86
The waste ink tank is about to become full.
(Operation will continue in this condition.)
Transfer the waste ink into a container.
"Emptying waste ink tank" on page 86
Slot * ink is low.
Get a replacement cartridge ready.
Reading S/C Card has been failed.
Insert ink cartridge again. If S/C Card still cannot be read, insert new ink
cartridge.
Ink cartridges are inserted in wrong slots.
Insert ink cartridges correctly again.
The ink cartridge cannot be used for this printer.
Contact your local MUTOH dealer.
Description
Description

Error message display and remedies

111