MUTOH ValueJet VJ-426UF Operation Manual page 42

2.
How to check the print range
This section explains about when the checking method is set to "Step".
Note
When it is set to "Auto", the following steps 2 to 5 are skipped. After step 1, the LED pointer moves from the "position1" to "position4" in order.
[1]
Start Show Edges
Wait for a while
Confirming PrintArea
[2]
Position 1 OK?
Confirming PrintArea
42 Checking the print range
• When the media is set and the print data is sent to the printer, the
left message is displayed.
->E
• Press the [Enter] key.
If you press the [Cancel] key, printing starts without checking the print range.
• The LED pointer moves to the bottom right corner of the print range
(position1) while the LED is turned off.
• After moving, the LED pointer flashes every second, for a total of 3
times.
Check that the LED pointer's position is not misaligned with the media
position, and then press the [Enter] key.
• The LED pointer remains on until the [Enter] key is pressed.
• Printing is canceled when the [Cancel] key is pressed.
• The LED pointer moves to the bottom left corner of the print range
(position2).
• The LED pointer remains on while moving.
• After moving, the LED pointer flashes every second, for a total of 3
times.
When the print data's width (Y direction length) is too big for the media, the
LED pointer flashes twice a second, for a total of 6 times after moving.
Note
Note
Note