MUTOH ValueJet VJ-426UF Operation Manual page 41

1.
Setting "Show Edges" function
[1]
1
Press!
2
[2]
Menu1:
[3]
Set1:
[4]
User:
Important!
If you have changed the user type to another type, all settings that can be changed by user type settings change to the settings of
the selected user type.
• When the "media setting" for the user type settings have been changed, the settings for the "media size" , "media location" ,
and "origin position" are changed to the settings of the selected user type. Therefore, be careful with the print start position.
Images might be printed at the position that was not intended or outside the media.
• You can change the settings for the "media setting" from the Panel Setting menu.
"**>5: MediaSetting" on page 59
[5]
**>7:
[6]
Show Edges:
Show Edges:
Show Edges:
[7] Press the [Enter] key to confirm.
Media Set
Low speed
Set Media
Setup >
User Type
Type 1
Show Edges
STEP
AUTO
OFF
Press the [Menu] key.
Press the [>] key.
Press the [Enter] key.
• Use the [+] or [-] key to select the user type from Type 1 to Type 10.
• Press the [Enter] key.
• Press the [-] several times to display the left screen.
• Press the [Enter] key.
Use the [+] or [-] key to select the setting.
• Step: LED pointer checks with the user at the point on the four corners to
show the print range.
• Auto: The LED pointer shows the print range without checking with the
user.
• Off: The print range is not shown. This is the default setting.
Checking the print range 41