MUTOH ValueJet VJ-426UF Operation Manual page 112

[*] S/C CodeErr
[*] Broken Chip
[******]Check Ink
[*]Reseat Ink
Err!Reboot a printer
Life Times [Head]
Life Times [Pump]
Life Times [CR Motor]
Life Times [PF Motor]
Life Times [C Pump]
Life Times [UV Lamp]
Shake W Cartridge
Shake KMCY Cartridge
Shake KMCYW Cartridge
Shake ALL Cartridge
Life Warning [CPump]
112 Error message display and remedies
Display
Inserted ink cartridge is not a proper one.
Contact your local MUTOH dealer.
S/C Card has been broken.Insert new ink cartridge.
Ink cartridges were not recognized correctly.
Insert ink cartridges correctly again.
Contact your local MUTOH dealer.
Because the Smart chip card is poor in contact, the reinsertion of the ink
cartridge is necessary.
Reseat all the ink cartridges.
Activation has failed. Restart the printer and carry activation out once more.
The operational life of the print head has almost expired.
(Continues operation)
Contact your local MUTOH dealer.
The operational life of the pump motor has almost expired.
(Continues operation)
Contact your local MUTOH dealer.
The operation life CR motor has almost expired.
(Continues operation)
Contact your local MUTOH dealer.
The operational life of the PF motor has almost expired.
(Continues operation)
Contact your local MUTOH dealer.
The operational life of Circulation pump motor is almost expired.
(Continues operation)
Contact your local MUTOH dealer.
The operational life of UV LED has almost expired.
(The operation continues.)
Contact your local MUTOH dealer.
Shake the White (Wh) ink cartridge.
Shake the Black (K), Magenta (M), Cyan (C), and Yellow (Y) ink cartridges.
Shake the Black (K), Magenta (M), Cyan (C), Yellow (Y), and White (Wh) ink
cartridges.
Shake all ink cartridges.
Shake the Black (K), Magenta (M), Cyan (C), and Yellow (Y) ink cartridges.
You must replace the Circulation Pump.
Please contact your Mutoh dealer to replace the Circulation-Pump.
If you want to stop the beep and continue printing, follow these steps.
1. Press the [Enter] or [Cancel] key to stop the beep.
2. The message "MaintenanceCall?" appears on the operation panel. Use the
[+]/[-]key to select [Yes] or [No].
3. Press the [Enter] key.
• When [Yes] is selected, the message "Ready To Print" will appear on the
operation panel. You can continue printer operation.
• When [No] is selected, the message "Printer Stop Shortly" will appear on
the operation panel. Go to Step 4.
4. Press the [Enter] key. The message "Ready To Print" appears on the
operation panel.
Description