Error Requiring Restart - MUTOH ValueJet VJ-426UF Operation Manual

Error requiring restart

An error requiring restart is displayed if a fatal operational failure such as the following occurs.
• When an obstacle that prevents printing occurs.
• When a problem occurs with the electrical circuit (PCB, motor, sensor, etc.) of the printer
• When a failure in the printer control program occurs.
If an error requiring restart occurs, the printer stops operating after performing the following operations.
1. The drive power automatically shuts down.
2. All lamps on the operation panel blink, and the buzzer rings continuously.
3. The error message is displayed on the operation panel.
Pressing any key on the operation panel stops the beeping.
For an error requiring restart, operation will return to normal after removing the cause of the error and restarting the printer.
If the same error continues to be displayed, contact the your local MUTOH dealer.
Be sure to tell us the code no. of the error message when you contact us.
Emergency Mode: E ***
Emergency Mode: AC
Emergency Mode: CPU
Emergency Stop
Reboot a printer
Note
" *** " in the error message is the code no. that indicates what type of error occurred.
114

Error requiring restart

Display
A problem that does not have a remedy has occurred.
1. Check if the replaced parts are installed correctly.
2. Turn the power button off. Wait a short while, then turn the power
button on, to restart the printer.
The power was shut down instantaneously while the printer is operating.
1. Turn the power button off. Wait a short while, then turn the power
button on, to restart the printer.
CPU error occurred.
1. Turn the power button off. Wait a short while, then turn the power
button on, to restart the printer.
Emergency stop button is pressed. The printer will stop operation.
1. Resolve the cause(s) of the emergency stop, and make sure there are no
problems.
2. Turn the emergency stop button clockwise, to turn it off and cancel the
emergency stop status.
3. Turn the power button off. Wait a short while, then turn the power
button on, to restart the printer.
"Emergency stop button" on page 46
.
Description