Transporting - MUTOH ValueJet VJ-426UF Operation Manual

Transporting

3

Transporting

Please refer to this section when transporting this product.

Transporting

When transporting this product, it is necessary to discharge the ink in the printer and waste ink and fixate the print head and
the table with packaging material. If transported as it is, it can cause ink leakage and damage to the print head.
When it is used again, conduct reinstallation work and initial charging.
Important!
• When moving this product, always empty the waste ink tank even if it is for a short distance.
If ink splashes inside the waste ink tank while being moved, it can cause damage.
• Do not tilt, set against something or place this product upside down.
Otherwise the ink may leak or the handling mentioned above may cause abnormality.
1.
Discharging the ink in the printer and waste ink
[1]
1
Press!
2
[2]
Menu 3 :
[3]
Mnt.4 :
[4]
Ink Discharge :
[5]
Empty WasteInk
[6]
Remove Cartridges
Media Set
Low speed
Set Media
Maintenance>
Ink Discharge
Start
->E
Press the [Menu] key.
• Press the [ - ] key several times, to bring up the display on the left.
• Press the [>] key.
• Press the [ - ] key several times, to bring up the display on the left.
• Press the [Enter] key.
Press the [Enter] key.
When the message on the left appears, transfer the waste ink into a
container.
"Transfer the waste ink" on page 87
tank"
• Press the [Enter] key.
• The message on the left will appear.
under "Emptying waste ink
Transporting 103