Error Message Display And Remedies - MUTOH ValueJet VJ-1638UH Operation Manual

7 Troubleshooting
7.2.2

Error message display and remedies

This section describes error messages and remedies.
Error messages are displayed when certain failures occur during printer operation.
If an error that can be displayed occurs, the printer may display the following error messages on the
operation panel and stop operation.
If the printer stops operating, solve the error so that the printer restarts.
No. Display
1 Cover Open
2 Maint. Cover L Open
3 Maint. Cover R Open
4 Undefined Media
5 Media Slant
6 Media End
7 Print End
Media End
8 Check Media Size
Media End
9 [*******] Ink NearEnd
10 [*******] InkEnd
11 [*******] NoCartridge
12 [*******] Discharged
13 Full WasteInkTank
14 Life Times
[Head*]
15 Life Times
[Pump]
356
Description
The front cover is open.
Left Maintenance cover is
open.
Right Maintenance cover is
open.
Media detection has failed.
(Stops operation)
Media is fed obliquely.
(Stops operation)
The Media has run out.
(Stops operation)
The Media has run out.
(Stops operation)
Printing was completed.
Media ran out while printing. Load a new media.
The remaining amount of ink
is low.
(Continues operation)
Ink has run out.
(Stops operation)
Ink cartridge is not inserted.
(Stops operation)
Ink is not filled.
The waste fluid tank is full.
(Stops operation)
The operational life of the
print head has almost expired.
(Continues operation)
The operational life of the
pump motor has almost
expired.
(Continues operation)
VJ-1638UH OPERATION MANUAL
Remedy
Close the front cover.
Close Maintenance cover.
Close Maintenance cover.
Reload the media.
Reload the media.
Load a new media.
To continue printing, load a
new media.
Replace with a new ink
cartridge.
Replace with a new ink
cartridge.
Insert Ink cartridge.
Perform initial ink charging.
Dispose of waste fluid.
Contact your local MUTOH
dealer.
Contact your local MUTOH
dealer.
Reference
3.5 Setting
media
2.2 Names of
parts and
functions
6.5.4 Daily
maintenance
3.5 Setting
media
3.5 Setting
media
3.5 Setting
media
3.5 Setting
media
3.5 Setting
media
6.4.1 Replaci
ng ink cartridges
6.4.1 Replaci
ng ink cartridges
6.4.1 Replaci
ng ink cartridges
3.4 Initial ink
charging
6.6 Disposal
the waste fluids
—
—
7.2 Error messages