MUTOH ValueJet VJ-426UF Operation Manual page 57

3. PF3. Confirm Print
PF3 : Confirm Print
• With a ruler, measure the length between "+" in the pattern.
• If there is discrepancy between the value set for "FeedLength" and the value measured, carry the procedure out again from
1. "Initial Print". If there is no discrepancy, go to 4. "Micro Print".
• In the example below, the measured place is shown in blue dotted lines and arrows (the blue parts are not actually printed).
4. PF4. Micro Print
PF4 :
• Observe the pattern and verify the micro adjustment value. In the pattern, look for a place that has least white lines or
overlapping in images. The number printed below the pattern is the micro adjustment value.
• Enter the Micro adjustment value according to the print result.
Not adequate
-0.10
Note
The micro adjustment value saved becomes the pattern's standard value.
For example, if "-0.20" is saved as the micro adjustment value and a pattern is printed again, the number below the center pattern changes
from "0.00" to "-0.20", and the left edge to "+0.30" and right edge to "-0.70".
Performs Confirm Print. Enter the "FeedLength", and press the [Enter] key.
Print a "+" mark at the beginning, feed the media according to the setting value,
and print another "+" mark.
Setting values
FeedLength :
Performs Micro adjustment print.
Micro Print
Enter the appropriate micro adjustment value according to the print result.
Adequate Not adequate
-0.20 -0.50
Micro change value
+0.50 +0.20 +0.10
100 mm to <250 mm> to 300 mm
300mm
<> indicates the initial value.
0.00 -0.10 -0.20 -0.50
Set1: User Type 57