Error Message Display And Remedies - MUTOH VJ-1938TX Operation Manual

Error message display and remedies

This section describes error messages and remedies.
Error messages are displayed when certain failures occur during printer operation.
If an error that can be displayed occurs, the printer may display the following error messages on the operation panel
and stop operation.
Cover Open
Mainte. CoverL Open
Mainte. CoverR Open
Lower the lever
Lever Up
Undefined Media
Media Slant
End Of Media
Media End / Takeup Err
Open Gutter Cover
Heater Error
[******] Ink End
[******] NoCartridge
[*******] Discharged
Full WasteInkTank
[*] Ink Low
140

Error message display and remedies

Display
Front cover is open.
Close Front cover.
Left Maintenance cover is open.
Close Maintenance cover.
Right Maintenance cover is open.
Close Maintenance cover.
Media loading lever is raised.
Lower Media loading lever.
The media is not loaded.
Load the media.
「Loading the media」 P. 38
Media detection has failed. (Stops operation)
Reload the media.
Media is fed obliquely. (Stops operation)
Reload the media.
The Media has run out. (Stops operation)
Load a new media.
「Loading the media」 P. 38
The Take-up system switch is off. (Stops operation)
Set the Take-up system switch to outside roll or inside roll.
Ink gutter cover is open.
Close Ink gutter cover.
Your heater may be malfunctioning. (Stops operation)
Check the heater.
Ink has run out. (Stops operation)
Replace with a new ink cartridge.
「Replacing ink」 P. 104
Ink cartridge is not inserted. (Stops operation)
Insert Ink cartridge.
Ink is not filled.
Perform initial ink filling.
「Performing initial charging after head cleaning」 P. 135
The waste fluid tank has become full.
(Operation will stop when this happens.)
Immediately transfer the waste ink into a container.
「Emptying waste fluid tank」 P. 107
Slot * ink is low.
Get a replacement cartridge ready.
Description