MUTOH ValueJet VJ-426UF Operation Manual page 56

1. PF 1. Initial Print
PF1 :
• With a ruler, measure the length between "+" in the pattern.
• In the example below, the measured place is shown in blue dotted lines and arrows (the blue parts are not actually printed).
Important!
• The maximum setting value for the feed length will vary depending on the settings for "MediaSetting" , "Size" and "Length" in
the User Type. (The same applies to "Confirm Print" .)
• Some media lengths cannot be used.
For example, if a media has a length of 100 mm or below, "Media size error: Length" will appear on the panel and printing will
not be carried out.
2. PF2. Initial Change
PF2 :
56 Set1: User Type
Performs initial adjust print. Enter the "FeedLength", and press the [Enter] key.
Initial Print
Print a "+" mark at the beginning, feed the media according to the setting value,
and print another "+" mark.
Setting values
FeedLength :
Enter the value that you measured. Provided there is no discrepancy between
Initial Change
that value and the value set during initial adjustment printing, press the [Enter]
key to set the value.
Setting values
Init. :
100 mm to <250 mm> to 300 mm
300mm
<> indicates the initial value.
<Initial Print menu setting value>
290.0/300mm
± 10.0 mm
<> indicates the initial value.