Doing Layer Printing; Emergency Stop Button - MUTOH ValueJet VJ-426UF Operation Manual

Doing layer printing

This printer has the capability for layer printing.
• For details of layer printing, which uses ValueJet Layer Editor, see the ValueJet Layer Editor Operation Manual.
"Displaying Help or Manual" on page 20
• See the following related sections of Panel Setting Menus (Chapter 2 below):
"Adv. 1: Multi Strike" on page 62
"Adv. 9: Multi Layer" on page 66

Emergency stop button

The printer is equipped with an emergency stop button. The methods for using and resetting it are set out below.
[1]
Emergency Stop
Reboot a printer
[2]
Resolve the cause(s) of the emergency stop, and make sure there are no problems.
[3]
[4]
Press!
Option
1
46

Doing layer printing

1 2 3 4 5 6
Media Set
Press the emergency stop button.
• The printer will stop operation.
The message on the left will appear.
Turn the emergency stop button clockwise, to turn it off and cancel
the emergency stop status.
• Turn the power button off.
• Wait a short while, then turn the power button on, to restart the
printer.