MUTOH ValueJet VJ-426UF Operation Manual page 29

[5]
CAUTION
When closing the front cover, always use both hands and hold it by the portions specified.
Do not place your fingers on the edges of the printer's opening portion, or on any parts around those edges. Your fingers could
get caught and be injured.
[6]
Wait for a while
[7]
Detailed-Set :
Close the front cover slowly, holding it by the places shown in the
picture and using both hands.
Press the [Set Media] key.
• The message on the left will appear. The table will move inward, and
a check will be run using the obstacle sensor, to make sure that the
media will not contact with the head.
Note
If the table is still positioned too high, the following will appear in the order
given: "Obstacle Detected", "Press Remove Media", "key". Press the [Remove
Media] key and readjust the table's height.
Press the [Enter] key.
On
Important!
• This menu item only appears when the user Type are selected for the
first time.
• If you select "On" , you will have to input the media width, media
height, media set position and origin position after pressing the [Set
Media] key each time you set a media on the table.
• If you select "Off" via the [ - ] key, "Ready to Print" will be displayed
after pressing the [Set Media] key each time you set a media on the
table. In that case, the currently selected User Type values will be used
for the media width, media height, media set position and origin
position.
Setting up media 29