MUTOH ValueJet VJ-426UF Operation Manual page 30

3.
Inputting the media width and length
[1]
Width ：
[2]
Length ：
4.
Inputting the set position
[1]
SET
Moving Location Pos.
[2]
SET
Y
30 Setting up media
• Use the [+] / [ - ] key to input the media width.
483mm
• Press the [Enter] key.
• These menu items will only appear if "On" is set for "Detailed-Set".
• Any value from 30 mm to 483 mm can be set for the width.
• If media with width 483 mm is used, it will not be possible to input a Y-
• Use the [+] / [ - ] key to input the media length.
329 mm
• Press the [Enter] key.
• Any value from 30 mm to 329 mm can be set for the length.
• If media with length 329 mm is used, it will not be possible to input an X-
Press the [Enter] key.
X : 0.0 Y : 0.0
• These menu items will only appear if "On" is set for "Detailed-Set".
• If you know the media set position in advance, you can input it here, using
• For the set position, any value from 0.0 to 265.0 can be set for the X value,
• The table will move inward.
• The carriage will move to the set position, with its LED pointer lit
Use the keys to align the LED pointer right foreground of the media.
X : 10.0 Y : 20.0
• Use the [+] / [ - ] key to move the table forward/backward
• Use the [<] / [>] key to move the LED pointer leftward/rightward
Press the [Enter] key to set the position.
X
0.0
Note
direction value for the set position.
Note
direction value for the set position.
Note
the [+] /
[ - ] key to enter the X (longitudinal) value and [<] / [>] key to enter the Y
(lateral) value.
and any value from 0.0 to 453.0 for the Y value.
*These ranges will vary depending on the values set for the media width
and length.
steady.
(longitudinally).
(laterally).