Message Type Error Display And Remedies - MUTOH ValueJet VJ-1628TD Operation Manual

VJ-1628TD, VJ-2628TD OPERATION MANUAL
7.2.2

Message type error display and remedies

This section describes message type errors and remedies.
Message type errors are displayed when certain failures occur during printer operation.
If a message type error occurs, the printer may display the following error messages on the operation
panel and stop operation.
If the printer stops operating, solve the error so that the printer restarts.
No. Display
1 Undefined Media
2 Media Slant
3 End Of Roll
4 Full WasteInkTank
5 Life Times
[Head 1]
6 Life Times
[Head 2]
7 Life Times
[Pump]
8 Life Times
[CR Motor]
9 Life Times
[PF Motor]
10 Set Height to Low
11 Don't Start Sleep Mode
12 Smart/C Near End
Description
Media detection has failed.
(Stops operation)
Media is fed obliquely.
(Stops operation)
Roll media has run out.
(Stops operation)
The waste fluid tank is full.
(Stops operation)
The operational life of the
print head 1 has almost
expired.
(Continues operation)
The operational life of the
print head 2 has almost
expired.
(Continues operation)
The operational life of the
pump motor has almost
expired.
(Continues operation)
The life CR motor is almost
expired.
(Continues operation)
The operational life of the PF
motor has almost expired.
(Continues operation)
The head height is set to High
during the procedure to turn
the power OFF, or during the
head washing, ink
replenishment, or head
cleaning.
(Stops operation)
Sleep Mode cannot be
performed because the printer
is not normal condition.
(Stops operation)
The remaining amount of ink
in the Smart/C is low.
(Continues operation)
7-11
Remedy
Reload the media.
Reload the media.
Load a new roll media.
Dispose of waste fluid.
Contact your local MUTOH
dealer.
Contact your local MUTOH
dealer.
Contact your local MUTOH
dealer.
Contact your local MUTOH
dealer.
Contact your local MUTOH
dealer.
Return the head height to
Low.
Return the product normally.
Charge Smart/C.
7 Troubleshooting
Reference
3.5 Setting
media
3.5 Setting
media
6.1.2 Replacing
roll media
6.3 Disposal of
waste fluids
—
—
—
—
—
3.2.2 Turning the
power OFF
5.7.1 Set Timer
menu
5.7.2 Sleep
Mode Start menu
—