MUTOH ValueJet VJ-426UF Operation Manual page 64

Adv. 6: Header Dump
Adv. 6 :
Note
• The data will be useful when contacting technical support.
• Performing printing if the printer is connected to PC, the print settings of RIP soft you are using are printed on data header.
Adv. 7: Spitting
Adv.7 :
Note
Spitting is a maintenance operation for preventing clogging of the print head's nozzles. It consumes ink.
Pass Count
Spitting :
Note
If the number of spitting returns is set high, there is a higher chance of nozzle clogging when printing for a long time.
In such a case, print quality cannot be guaranteed.
64 Set2: Advanced
Sets whether to print the following information when printing.
Header Dump
(Required media size: width 250 mm x length 50 mm.)
• Data header
• Data dot number (printed only when Header damp setting is ON)
• Printer serial number
• Firmware version
Setting values
Header Dump :
Header Dump : On
Header Dump :
Sets up the spitting operation while printing.
Spitting
• The display will shift to setting of the pass count only if "On" is set for "Spitting".
Setting values
Spitting :
This is for setting the interval at which the print head will carry out spitting
On
operation.
• The head will carry out spitting operation every time it completes the number
of passes that you set here.
Setting values
Pass Count :
Dump data is not printed.
Off
This is the default setting.
Dump data is printed after the original
image is printed.
Prints only damp data.
Dump
"Data dot number" is not printed.
<On> / Off
On
<> indicates the initial value.
<1 time> to 999 times
1 cnt