MUTOH ValueJet VJ-426UF Operation Manual page 66

Adv. 9: Multi Layer
Adv.9 :
Note
• If you select "Off" for this, then when printing of a print data set ends, you will have to set the media in place again before sending the
next data set.
• If you select "On" for this, then the media status will be retained when printing of a print data set ends, and by sending the next data set
you can print another layer over the previous printing.
• In the case of "Adjust Print", "PF Adjust" or "Test Print", you will have to set the media in place again even if you select "On" for this.
Adv.10: White Maintenance
Adv.10 :
Note
White ink tends to settle or coagulate inside the print head or ink tubes.
Therefore, the printer regularly discharges a small amount of white ink to maintain the performance, even in standby status.
66 Set2: Advanced
This is for setting layer printing.
Multi Layer
Setting values
Multi Layer :
Sets up white ink's maintenance operation.
White Mainte.
• If you do not usually use white ink for regular printing, set to "Little" to curb
white ink consumption in standby status.
• This submenu will only appear when 6-color is set.
Setting values
White Mainte. :
White Mainte. :
<Off> / On
Off
<> indicates the initial value.
White ink maintenance operation will be
Normal
carried out at a normal frequency.
This is the default setting.
White ink maintenance operation will be
Little
carried out at a lower frequency.