MUTOH ValueJet VJ-426UF Operation Manual page 55

**>3: PF Adjust
**> 3 :
Steps
1.
Print a "PF1: Initial Print", and measure the distance between the "+" marks with a ruler.
2.
Enter the distance measured as the "Initial Change".
3.
Determine the feed length for the "PF3: Confirm Print", print it, and measure the distance between
the "+" marks with a ruler.
• Check that there is no deviation from the feed length.
4.
Print a "PF4: Micro Print", and find the pattern with the least white streaks and image overlaps.
• The numeral below that pattern is the micro adjustment value.
5.
Enter the micro adjustment value according to the print result in Step 4.
Sets up various settings on the Media feed correction.
PF Adjust>
• Required media size: width 210 mm x length 110 mm.
• A ruler is used for this adjustment. Please prepare a commercially available
ruler.
When the following defects are found in print results, they may improve by
conducting a paper feed correction.
• Images are overlapping.
• There are white lines in images.
Submenus
PF1 :
PF2 :
PF3 :
PF4 :
PF5 :
"1. PF 1. Initial Print" on page 56
Initial Print
"2. PF2. Initial Change" on page 56
Initial Change
"3. PF3. Confirm Print" on page 57
Confirm Print
"4. PF4. Micro Print" on page 57
Micro Print
"5. Micro Change" on page 58
Micro Change
Set1: User Type 55