Applying additional UV light after printing
When you want to promote ink curing, you can apply UV-LED light additionally after printing.
This is useful for the following cases.
• When printing on media that soaks ink, such as a cloth and so on.
• When printing an image that uses a lot of ink
• When the ink film is thick from layer printing
[1]
1
Press!
2
[2]
Menu3: Maintenance>
[3]
Mnt.3: UV Scan>
[4]
UV Scan1: Start
Note
• The range to apply the UV-LED light depends on the user type's [MediaSetting] – [Size] and [Location] settings that are currently selected.
• See the following when changing the number of reciprocating motions for every 1 inch in the media feeding direction while performing
UV scanning.
"UV Scan2: Scans" on page 74
• To apply additional UV-LED light automatically every time after printing, see the following.
"UV Scan3: Post Cure" on page 74
For details on the related sections of the Panel Setting menu, see the following.
"Mnt.3: UV Scan" on page 74
Media Set
Low speed
Set Media
After printing, press the [Menu] key.
• Press the [-] several times to display the left screen.
• Press the [>] key.
• Press the [-] several times to display the left screen.
• Press the [Enter] key.
Press the [Enter] key.
• UV-LED light application starts.
Applying additional UV light after printing
45