New Holland CX720 Repair Manual page 2724

4. Install the shimpac and bearing housing (2) with
seals and bearing outer ring.
NOTE: The tickness of the shimpac should be so that there
is a little axial end play on the input shaft.
5. Tighten bolts (1) to a torque of 50 Nm (37 ft.lbs).
Install a dial gauge on the housing and locate the
probe on top of the shaft.
Apply a load in one direction and oscillate the shaft
several times while the load is applied.
Set the dial gauge to zero.
Apply the load in the opposite direction, oscillate and
read the axial movement of the shaft.
6. Make three measurements at 120 ° of the shaft. Cal-
culate the arithmetic mean of the three readings.
The axial end play should be 0.01-0.06 mm (0.0004-
0.0025 in).
7. If required, adjust the thichness of the shimpac. To
decrease the axial end play, decrease the quantity of
shims.
8. When the thickness of the shimpac is determined,
apply thread locking compound type 1 (Loctite 242)
to bolts (1) and tighten them to a torque of 50 Nm (37
ft.lbs).
TRAVELLING - FRONT AXLE
2 4/7/2006
D.10.A / 70
4
ZDA4902A
5
ZDA4903A