New Holland CX720 Repair Manual page 2734

10. If the center section is to be removed, inspect the
seals and bushings at (1), for unusual wear char-
acteristics. Replace the seals and bushings as re-
quired. Install the seals with the cupped side out.
Apply a generous layer of grease to the bushings and
seals. Position the center section under the combine
and raise it up to the appropriate mounting hole.
11. Apply a generous layer of grease to the pivot pin.
Adjust the height of the jack as required and insert
the center section pivot pin (1) into the axle mount.
Install the split spacer into its original position.
12. Set the washer and shims into position onto the end
of the pivot pin. Turn on the castellated nut (1) and
torque to 115 N·m (85 ft. lbs.). Install the cotter pin
(2) to secure the nut into place.
TRAVELLING - REAR AXLE
2 4/7/2006
D.12.A / 6
9
10010513
10
10010510
11
10010511